Acom 1400 soled state amplifier 1,8-54 Mhz Model 2026

SPECIAL SALE MODEL 2026

DO YOU HAVE  INTEREST INTO THE ACOM 1400S  ,PLEASE GIF US YOUR NAME VIA THE MAIL ORE MAKE A PRE-ORDER.

PRICE ARE  3999 EURO DELIVERY IN  2026

TRANSPORTCOST ARE EXTRA TO PAY 1 COLLY FOR THE DEAL, 1 BOX FOR ONLY THE A-1400S

CALL FOR TRANSPORTCOST  OUTSIDE THE NL, AND TRANSPORTCOST OUTSIDE THE  EU , CALL FOR TRANSPORT COST. +( 20 euro transport Insurance )

Acom 1400 soled state amplifier 1,8-54 Mhz

EXPORT WE MUST CHARCH YOU THE VAT FROM YOU COUNTRY

Standard Frequency Coverage

• All amateur bands from 1.8 through 54 MHz:
  • 1.800 - 2.000 MHz (160 m band)
  • 3.500 - 4.000 MHz (80 m band)
  • 5.020 - 5.455 MHz (60 m band)*
  • 7.000 - 7.300 MHz (40 m band)
  • 10.100 - 10.150 MHz (30 m band)
  • 14.000 - 14.350 MHz (20 m band)
  • 18.068 - 18.168 MHz (17 m band)
  • 21.000 - 21.450 MHz (15 m band)
  • 24.890 - 24.990 MHz (12 m band)
  • 28.000 - 29.700 MHz (10 m band)
  • 50.000 - 54.000 MHz (6 m band)*
• (*) Please, refer the applicable regional band plans and laws for specific allocations and limitations;
• In specific business cases, extensions or changes of the frequency coverage can be discussed, but this must be agreed upon before ordering. In any case, this is not the producer's obligation and can not be against local rules and laws.

Rated Output Power

• 1200 W ±0.5 dB, PEP or continuous carrier, without mode limitation, at 200-264 VAC mains;
• 600 W if operated at 90-132 VAC mains.

Intermodulation Distortion (IM3)

• Better than 31 dB below rated PEP;

Harmonic and Parasitic Emissions Output Suppression

• -60 / -70 dB or less (HF/50 MHz band);

Input and Output Impedances

• Nominal value: 50 Ohm unbalanced, UHF (SO-239) type connectors;
• Input circuit: Broadband, SWR below 1.2 (1.1 typically), 1.8-54 MHz continuous range without retuning or switching;
• RF bypass path: SWR - below 1.1, 1.8-54 MHz;
• Acceptable SWR at the output load (the antenna): up to 3 with proportional power reduction and up to 1.5 for full output power;

RF Power Gain

• 14 dB ±1 dB (typically 50 W for 1200 W output power);

Mains Power Supply Voltage

• 100-240 VAC, ±10%, 50-60 Hz, Single phase;

Mains Power Consumption at Full Output Power

• Power factor of 0.95 or higher;
• Up to 3100 VA at rated output (200 VAC);
• Up to 2000 VA at 600 W output from 100/120 VAC;

Mains Power Consumption in Low Energy (Waiting) Mode

• Less than 1 VA;

Receive / Transmit Control

• KEY-IN - Phono RCA connector
  • Voltage applied to the transceiver keying output - up to +12 V;
  • Closed-circuit current flow to the transceiver keying output - up to 6 mA;
• KEY-OUT - open-drain Phono RCA connector
  • Output resistance: not more than 120 Ohm;
  • The maximum allowable open-circuit voltage coming from external devices connection: +50 V;
  • Maximum allowable closed-circuit current flow by external devices: 20 mA;
• Minimum required time of sequencing between sending a request for transmitting (KEY-IN "ground on transmit" signal) and applying RF drive power at RF INPUT connector for safely switching receive to transmit: 10 ms.

Safety and Electromagnetic Compatibility

• Complies with CE safety and electromagnetic compatibility requirements;
• The FCC (US Federal Communications Commission) certification is in process of organization as of October 2024;

Size & Weight (operating, excluding connected cables)

• Amplifier, WxDxH: 372x418x170 mm, 14,6 kg (14.7x16.5x6.7 inches, 32.2 lbs.);
• Remote Control Unit, WxDxH: 179x118x86 mm, 0.730 kg (7.1x4.7x3.4 inches, 1.6 lbs.);

Shipping Size & Weight

• Please, contact us for shipment details;

Operating environments

• Temperature range: -10 to +40 degrees Celsius (14 degrees F to 104 degrees F);
• Relative air humidity: up to 95% @ +35 degrees Celsius (95 degrees F);
• Height above sea level: up to 3050 m (10000 ft) without output deterioration.Many customers asked us:

• What is the warranty of the LDMOS transistors used in ACOM power amplifiers?
  The answer is easy, but first, please read these statements:
  NXP Semiconductors | LDMOS transistors producer | www.nxp.com(link is external)
  " ... NXP makes no warranty, representation, or guarantee regarding the suitability of its products for any particular purpose, nor does NXP assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. "Typical" parameters that may be provided in NXP data sheets and/or specifications can and do vary in different applications, and actual performance may vary over time. ...". 
  " ... (c.) Time Period. Except as provided in subsections (d) and (e) below, Products are warranted for a period of one (1) year from date of delivery to Buyer. ...".
  
  AMPLEON | LDMOS transistors producer | www.ampleon.com(link is external)
  " ... Seller warrants that under normal use the Products (excluding any Excluded Products) shall, at the time of delivery to Buyer and for a period of twelve (12) months thereafter (or such other period as may be agreed upon in writing by the parties), be free from defects in material or workmanship and shall substantially conform to Seller’s specifications for such Products, or such other specifications as Seller has agreed to in writing, as applicable. ...".

Extra RCA cable for TX long:1,20m price : 
Extra RCA cable for TX long:3,00m price : 

Connection Acom 1010 on Icom 756Pro 3:On ACC 2 7pin connecto
Connection Acom 1010 on Icom 7100 on special ACC cable13pin+cable 

Connection Acom 1010 to TS590/TS570 Kenwood with 7 pin Din:
Connection Acom 1010 to Yaesu FT897 (Cat/Tuner) with 8 pin mini Din:
Connection Acom 1010 to Yaesu FTDX 1200 with 10pin mini din to RCA: 
Connection Acom 1010 to Yaesu FTDX 3000 with RCA cable to TX Ground : 

Din connector:7 pins : 
Din connector:8 pins mini :
Din connector:10 pins mini : 
Din connector:13 pins: 
Din connector:13pins with 13 wire: