Acom 600S HF-6m-Warc Solid State Amplifier
Acom 600S HF-6m-warc
SPECIAL SALE: GB ANTENNES 30 YEAR: ACOM 600S COMPLETE WITH ACOM DUSTCOVER.
NEW ACOM 600S Solid State Amplifier, with new software update.
NOW MORE POWER WITH THE NEW UPDATE AND FINAL PROTECTION AND FIRMWARE 7.3
YOU CAN NOW ALSO TX WITH 200W INPUT IN THE STANDBY MODE FROM THE ACOM 600S,AND ALSO WHEN THIS ARE OFF LINE.
NOW DELIVERY FOR THE ACOM 600S A DUSTCOVER
ALSO NOW THE NEW ACOM AUTO TUNER ATU O4AT TO CONTROLE WITH THE ACOM 600-1200S MODEL LOOK ON THE WEBSITE FOR MORE INFORMATION.
Power: Max 800Watt +
Input 17 Watt drive output 600Watts
Input 20 Watt drive output 800 Watts
Frequency:1,8~54MHz EU model en US model ( TX on 60m band 5.300-5.500 MHz )
Europe model have NO block on 28/24MHz TX and are for 230/240V ( 110 V 120V option)
On/Off switch on the rear from the Acom
Standby switch on the front from the Acom
High resolution display:800x480 pixels and 24-bits colors
Mosfet Transistors:2x MRFE6VP6300H MP
Set MP:2 x MRFE6VP6300H :399,85 euro
Antenne Output: 1x SO239
Antenne Input: 1x SO239
Connector: KEY IN
Connector: KEY OUT
Current :110~220~230~240Volt( EU 230V)
Power current : 6-10Amp
Weight: 14,5kg (29,0lbs) Transport weight triple box (560mmx470mmx200mm)
( Acom 600S 12kg 24lbs)
Warranty:24mnd on the Electronica and 12mnd on the final
Transport cost outside europe call us first, on the website are the transport cost not correct.
Please mail the country where you are, so we can make you a offer for the Acom.
We ship with UPS DHL FEDEX DB schenker GLS, if you have a account by this company we can ship on your account to you.
Extra to order:
controle cable for FT950 with BCD code
You can order contole cable with BCD code for Kenwood-Yaesu
Icom CI-V Serial CAT TTL Cable
Now also banddata cable for the Flex radio's to controle the Acom to the Flex radio, please give your model for the correct cable.
Power:600 Watt Plus ( max 750 W).
Power Mosfet Transistors:Type MRFE6VP6300H (withstand high mismatch SWR).
High resolution color display:800x480 pixels and 24-bits colors.
Intermodulation distortions (IMD 3) better than 28dB (30dB typically) below the rated PEP output.
harmonic and parasitic emmissions output suppression better than 60dB (65dB typically).
Input and output impedances: Nominal value: 50Ohm unbalanced.
UHF (SO239) Type connectors.
Input circuit: Broadband, SWR below 1.2:1 (1.1:1 typically).
Frequency :1.8-54Mhz continous range without retuning or switching.
RF by-pass path SWR-below 1.1:1 from 1.8-54MHz.
Admissible SWR at the output load (the Antenna) up to 3:1 with proportional power reduction and up to 1.5:1 for full output power.
RF power gain: 14db+/-1dB ( typically 25W for 600W output power.
Mains power supply voltage:85-132V with 10A main fuses and 170-265V with 6,3A main fuses, 45-66Hz single phase.
Mains power consumption in Low Energy ( stand by mode) less than 1VA.
Temperature rqnge: -10 C to + 40 C ( 14 Fto 104 F).
Relative air humidity: up to 95- - 35 C ( 95 F).
Dimensions ( projections not included) and weight 12kg( 26,5 lbs).
(W x H x D) 330 x 165 x 380mm ( 13 x 6,5 x 15 ").